Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Beverly Hills
Dryer vent cleaning in Beverly Hills typically runs $160 to $275 for a standard single-family home, and we complete most jobs in under 90 minutes. We know the Flats, the streets above Sunset, and the older estate properties where lint has been building up for years without anyone noticing. If your dryer is running longer than it used to, or the laundry room feels warm and humid after a cycle, call Brownstone Chimney Sweep at (866) 253-8489 and we’ll get a technician to your Beverly Hills home quickly.
Why Brownstone Chimney Sweep Is Beverly Hills’s Preferred Dryer Vent Cleaning Company
We’re a dedicated chimney and vent specialist, not a general handyman operation that picked up a dryer vent brush as a side service. Our Dryer Vent Cleaning team works exclusively with professional-grade equipment and the same attention to system condition we bring to chimney work. Beverly Hills homeowners call us because we understand that a 1920s Spanish Colonial Revival estate has different venting realities than a hillside contemporary, and we inspect accordingly.
Ruben Archuleta leads our crew, and he’s been clear about the standard from day one: we don’t clear a vent and walk away. We check the full path, from dryer hookup to exterior termination, because that’s where Beverly Hills properties hide their problems. The same neglect we find in converted gas log fireplaces shows up in original laundry service shafts: systems nobody has looked at in decades, quietly packing lint against hand-finished plaster and old masonry. We write it all up, show you photos, and tell you plainly what needs attention now and what can wait.
Our technicians know the streets between Santa Monica Boulevard and the hills, the gated drives off Sunset, and the older pockets near the Civic Center where homeowners still run original clay-tile exhaust routes. That local familiarity means we arrive prepared for what’s actually in your walls, not what a generic checklist expects.
Key takeaways:
- Beverly Hills estate homes often have original 1920s – 30s service shafts that were never sized for modern dryer lint volume.
- Long, dry fire seasons let lint and debris accumulate silently for months between uses.
- We’re a chimney and vent specialist, led by Ruben Archuleta, and we stock professional-grade parts for Beverly Hills callouts.
- Every job includes a full vent-path inspection, not just a brush through the pipe.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Beverly Hills
Beverly Hills homes throw unique challenges at a dryer vent line, and our service scope reflects that. We offer four core services, each tailored to the housing stock and fire-safety realities of Beverly Hills.
Full Dryer Vent Line Cleaning and Lint Removal
We run the entire vent path from the dryer’s exhaust collar to the exterior termination point, removing lint, nesting material, and debris. In Beverly Hills estates, that path can be long, with multiple bends, and we use professional rotary brushes sized to the actual duct, not a homeowner-grade kit. Most homes in 90210 and 90212 take 60 to 90 minutes for a complete cleaning.
Exterior Termination and Vent-Path Inspection
The vent cap on a Beverly Hills home gets sun, Santa Ana wind, and occasional roof traffic. We find crushed terminations, rusted caps, and vents buried behind overgrown hedging along the Flats. After cleaning, we verify proper draft at the termination and flag any damage or restriction that would send lint back into the living space.
Gas Log Conversion Safety Inspection on the Associated Flue
This is the part most dryer vent companies miss entirely. When a Beverly Hills estate fireplace was converted to a gas log set decades ago, the flue often became an afterthought. If your dryer vent runs through the same wall system or shares a masonry chase with that fireplace flue, blocked or deteriorating flue conditions can create cross-contamination and humidity problems. We inspect both paths while we’re on site, using HeatShield resurfacing knowledge and camera inspection to document what’s actually there.
Converted Service Shaft Clearing and Restoration
Homes built before 1940 in the Flats often have laundry service shafts that originally vented a gas line or simply dead-ended inside a wall. Over the years, those shafts were repurposed for electric dryer exhaust, but nobody resized them. We clear those narrow paths carefully, using Gelco service in Beverly Hills brush systems that handle old masonry-lined chases without gouging the surrounding plaster or tile work.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Beverly Hills
We don’t carry hardware-store parts. Our truck stock for Beverly Hills callouts includes Famco vent caps and termination hardware, Gelco professional brush systems sized for long and narrow estate vent runs, and HeatShield ceramic resurfacing products for flue work that overlaps with dryer vent concerns. When we install a new vent cap or replace a damaged section, we use the same brands professional chimney and vent technicians specify. That means the repair holds up to Beverly Hills weather and the long idle periods between heavy-use stretches.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Beverly Hills Homes
Beverly Hills properties share certain failure patterns, and we’ve learned to look for them before the first brush goes in.
- Lint packing in undersized original chaseways: 1920s and 1930s Spanish Colonial Revival and Tudor homes in the Flats were plumbed for a different era. The service shafts that now carry dryer exhaust were never sized for a modern dryer’s lint output, so they clog faster than newer construction. A three-inch path that worked for a 1950s dryer chokes after a few years of high-efficiency use.
- Dead flue syndrome from gas log conversions: Converted fireplaces often left the flue unlined and unswept for decades, and the same neglect shadows the adjacent dryer vent. When both systems sit idle through a long warm season, lint and creosote accumulate side by side without any obvious symptom until airflow drops hard on a heavy laundry day.
- Santa Ana wind-driven backdraft: Exterior terminations on hillside streets above Sunset face strong Santa Ana gusts that can force exhaust back down the vent. We see vent caps blown open, dampers stuck, and lint blown backward into the duct. A properly fitted Famco cap with a working damper solves most of it.
- Clay-tile roof clearances: Beverly Hills homes with original clay-tile roofs often have vent terminations tucked low under eaves, where overhanging tile creates a dead-air pocket. Lint accumulates at the exterior termination year-round, and we clear it as part of every cleaning. We also recommend raising the termination or repositioning it when the roof pitch makes the current location unserviceable.
Pricing for Dryer Vent Cleaning in Beverly Hills, CA
A standard dryer vent cleaning in Beverly Hills runs $160 to $275, covering a single dryer, up to a 25-foot vent path, and the exterior termination inspection. Longer runs common in hillside estates, multiple bends in converted shafts, or vent paths that run through old masonry chases add $50 to $120. If we’re clearing a packed legacy shaft from a 1930s estate, the full vent-path restoration work typically lands between $300 and $475, including the camera documentation and draft verification. Gas log flue inspection alongside a dryer vent cleaning is quoted separately, but you’ll get a firm price before we start anything. Call (866) 253-8489 for a free estimate, and we’ll tell you exactly what your Beverly Hills home needs, with no pressure to approve work that can wait.
We Also Serve Cities Near Beverly Hills
Our crew works throughout the Westside and Los Angeles, including Century City, West Hollywood, Culver City, and Hollywood. If you’re in any of those neighborhoods and need Dryer Vent Cleaning, we can schedule you quickly and bring the same estate-home experience we use in Beverly Hills.
Serving Beverly Hills, CA — Our Local Coverage Area
We’re based in the Beverly Hills area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Beverly Hills
Because the vent paths were never designed for what you’re asking them to do. Beverly Hills estate homes built in the 1920s and 1930s have original service shafts that were sized for gas-powered laundry equipment or simple dead-venting, not a modern electric dryer pushing lint at high velocity. Add a long dry season where the system sits idle and a Santa Ana wind cycle that pushes debris backward into the duct, and you’re looking at a vent that should be cleaned every 12 to 18 months, regardless of the dryer manufacturer’s brochure. Call (866) 253-8489 and we’ll inspect what’s actually in your walls.
A gas log conversion in a Beverly Hills estate often means the fireplace flue was capped or left unlined, and no one touched it for decades. If the dryer vent shares a masonry chase with that flue, or runs alongside it, the dead flue creates a cold, damp zone that can condense lint and pull humidity into the chase. During a dryer vent cleaning, we inspect the adjacent flue path and photograph it, because the two systems often fail together in older homes. The fix may be nothing, or it may be a small HeatShield resurfacing or liner cap, but you’ll see the evidence before you spend anything.
Dryer cycles running longer than 45 minutes, a musty smell in the laundry room, clothes coming out hot but damp, and a lint smell outside the vent termination after every load. On hillside streets, you may also see the vent cap flapping in Santa Ana winds or notice that the exterior lint trap looks stained and clogged. If you have to run a second cycle to dry a standard load, that’s a blocked vent path, not a broken dryer. We’ll clear it and show you the before-and-after airflow readings.
Yes. Clay-tile roofs on Beverly Hills homes often position the dryer vent termination low under the eaves, where the tile overhang creates a stagnant air pocket. Lint collects at that termination and works its way back into the duct. It also means the vent cap itself is harder to reach and inspect. We clean the termination from both sides, verify the damper opens freely, and if the termination is in a dead-air zone, we’ll recommend a repositioning that works with the roofline instead of fighting it.
Yes, and in Beverly Hills, it usually should. The linkage between converted gas log fireplaces, dead flues, and adjacent dryer vents is a recurring pattern in older estates. We arrive for the dryer vent and, with your approval, inspect the fireplace flue at the same time. If the flue needs sweeping, a liner repair, or a HeatShield ceramic resurfacing, we can quote it on the spot and often complete it the same day. You get one crew, two systems, and a single clear report on what’s actually happening inside your walls. Call (866) 253-8489 to book both.
Written by Ruben Archuleta, Owner at Brownstone Chimney Sweep, serving Beverly Hills and the surrounding communities.